Configuring Remote Control Id And Projector Id Settings; Using The Presentation Timer (Timer); To Display The Timer; To Display The Timer Function Menu - Casio XJ-UT351W User Manual

Configuring Remote Control ID and Projector ID
Settings
The remote control ID and projector ID are numbers from 1 to 4. If the two IDs match, you will be able
to perform all projector operations from the remote controller. This function helps to avoid remote
control conflicts when there are multiple projectors (up to four) in the same area.
The initial factory default setting of both the remote control ID and projector ID is "All", which means
that the remote controller signal can be sent and received regardless of the ID of the sending/receiving
device.
The "Specify a remote control ID" operation in the table below can be performed on the remote
control unit only. This operation can be performed even if the projector is turned off. For the other
operations, first start image projection operation and then perform the operation.
To do this:
Specify a remote control ID While holding down the remote controller [ESC] key, press one of the keys below.
Specify a projector ID
Check the current remote
control ID and projector ID
settings

Using the Presentation Timer (TIMER)

The presentation timer shows a countdown from a preset time value. You can use it to keep track of
how much time has elapsed during your presentation, and to limit a presentation to a preset amount of
time. You can configure the presentation timer so it is displayed in the projected image.

To display the timer

When the timer is not displayed on the projected image, press the [TIMER] key once.
The timer will appear for about five seconds and then disappear automatically if the "Off" is selected
for the "Continuous Display" setting on the timer function menu.

To display the timer function menu

When the timer is not displayed on the projected image, press the [TIMER] key twice. If the timer is
displayed, press the [TIMER] key once.
Perform this operation:
 [1], [2], [3], or [4]: Sets the number of the key you press as the remote control ID.
 [MENU]: Changes the remote control ID to "All".
1. Press the [MENU] key to display the setup menu.
2. Select "Option Settings 1", "Projector ID", and then press the [ENTER] key.
3. Use the [] and [] keys to select a number from 1 to 4 or select "All", and then
press the [ENTER] key.
While holding down the remote controller [ESC] key, press the [INPUT] key. This will
project the remote control ID and projector ID for about 10 seconds. The remote
control ID and projector ID shown by this operation may not match each other.
30