Table of Contents
Advertisement
10.
To terminate the wireless LAN connection and discontinue computer screen
projection, click the close button (
Connection window.
This closes the Network Connection window and returns the projected image to the LAN
connection standby screen.
Note
The login code is updated to a new value each time the projector is started up. Each time you
perform the above procedure to connect, check the login code on the projection screen and
input the correct login code for the current startup.
If the projector cannot be found in step 6 of the above procedure, the Network Connection
window appearance will change as shown below.
If this happens, check the points listed below, click [Reconnect], and then perform the above
procedure again from step 6.
Check if the wireless adapter is correctly connected to the projector.
See "Connecting the Wireless Adapter to the Projector" (page 10).
Check if the projector is turned on and projecting the LAN connection standby screen.
Confirm that the SSID in the lower left corner of the LAN connection standby screen is any
one of the following: casiolpj0001, casiolpj0002, casiolpj0003, casiolpj0004.
If a different SSID is shown, perform the above procedure from step 2.
) in the upper right corner of the Network
14
Advertisement
Table of Contents
