Table of Contents
Advertisement
5.
To restart the projector and reflect the changed settings, click [OK].
To cancel projector re-start without changing settings, click [Cancel] instead of [OK].
Clicking [OK] will reflect the changed settings and restart the projector. The LAN connection
between the projector and computer will be terminated at this time.
To configure Network Settings page network settings
1.
Referring to "Logging In to the Projector Admin Pages over a Wireless LAN
Connection" (page 53), log in to the Projector Admin pages.
2.
On the left pane, click "Network Settings".
3.
On the "Network Settings" page that appears, configure the settings described
in the table below.
To do this:
Specify auto acquisition of an IP
address from the external LAN
device
Specify the IP address manually
Specify auto allocation of IP
addresses to computers and smart
devices by the projector
Specify no allocation of IP addresses
to computers and smart devices by
the projector
Enable wireless LAN connection to
the projector from a computer and/or
smart device (by enabling the built-in
access point function)
Disable wireless LAN connection to
the projector from a computer and/or
smart device (by disabling the built-in
access point function)
Create a user SSID
Enable/disable SSID broadcasting
Specify the channel for wireless LAN
communication
Specify auto selection of the wireless
LAN channel to be used
Perform this operation:
In the "IP Settings" area, click "Obtain an IP address automatically".
(1) In the "IP Settings" area, click "Use the IP address below".
(2) In the "IP Address" boxes, enter the IP address you want to assign to
the projector (Initial Default: 192.168.100.10).
(3) In the "Subnet Mask" boxes, enter a value that will be used to determine
range of IP addresses of the network (subnet) to which the projector will
belong (Initial Default: 255.255.255.0).
(4) In the "Default Gateway" boxes, input the IP address of the default
gateway (Initial Default: 192.168.100.10).
(1) In the "DHCP Settings" area, click "Auto".
(2) Specify the range of automatically allocated IP addresses as required.
In "Starting Address" and "Ending Address", input a value in the
range of 11 to 254 for the fourth octet.
Only the fourth octet can be specified by you. The other octets
cannot be changed.
In the "DHCP Settings" area, click "Disable".
Change the "Wireless Settings" area "Access Point Function" setting to
"Enable".
Change the "Wireless Settings" area "Access Point Function" setting to
"Disable".
In the "Wireless Settings" area, configure the "SSID", "Security", and
"Passphrase/WEP Key Input" settings.
For details, see steps 6 through 8 under "To create a user SSID" (page 19).
In the "Wireless Settings" area, select "Enable" or "Disable" for "SSID
Broadcast".
In the "Wireless Settings" area, click [ ] on the right side of the "Channel"
box. On the list that appears, select a channel from 1 to 11.
In the "Wireless Settings" area, click [ ] on the right side of the "Channel"
box. On the list that appears, select "Auto".
60
Advertisement
Table of Contents
