Base Unit; Reset Handset Defaults - Doro 8085 User Manual

English
Register a New Handset or Base Unit
To enable the use of more than one handset a registration has to be performed.
Every new handset must be registered in order to use a base unit. A maximum
number of 4 base units can be registered with each handset, and each base unit
can handle up to 6 handsets.
On registration, the handset is allocated a handset number from 1-6.
Additional base units and handsets can be purchased from your local retailer.
See also page 24 for more information about Expanded Systems.
1. Hold the paging button
beeps. Registration mode will remain active for about 30 seconds.
2. Press until
w
3. Scroll to
SEttInGS
4. Scroll to
HAndSEt
5. Scroll to
rEgIStEr
6. Select a base number for the base unit you wish to register by pressing the
corresponding number button 1-4.
7. Enter the base unit PIN code (0000 at default). Press
8. After a few seconds (no more than 90) unused handset numbers are
displayed. Select one of these by pressing the corresponding number button.
9. If the registration is successful, the handset will return to standby mode
in a few seconds. The new handset number is shown on the right of the
display.

Reset Handset Defaults

You can reset most of the functions and settings of the handset (
or just the redial log (
or speed-dial numbers.
1. Press until
w
2. Scroll to
SEttInGS
3. Scroll to
HAndSEt
4. Scroll to
dEFAuLt SEt
5. Enter the handset PIN code (0000 as default).
6. Confirm by pressing
16
Settings
on the base unit down for a few seconds until it
j
PHOnE LISt SEt
. Press .
0
. Press .
0
. Press .
0
ErASE rEdIAL
PHOnE LISt SEt
. Press .
0
. Press .
0
or
ErASE rEdIAL
.
0
is shown.
). Resetting does not affect registrations
is shown.
. Press
0
.
0
dEFAuLt SEt
.
www.doro.com
)