Use From Base Unit; Outgoing Message - Doro COMFORT 1005 Manual

Note!
Even when answering machine is OFF it will still answer after 10 rings, see
Remote access,

Use from base unit

The digits on base unit will flash when there are new messages.
Switch the answering machine on/off.
!
Start playback/Stop playback.
/
Skip to previous/Skip forward.
/
Delete current message.
X
To delete all old messages after playback: Press and hold X until
you hear a beep.
Increase/decrease volume.
Note!
If the base displays – – the answering machine is disconnected, or time/date is
not set. You need to set the date and time to gain full functionality.
On/off from base unit
Press 1 (on the base unit) to switch the answering machine on/off. If the base
unit's display is flashing/showing – – the answering machine is disconnected,
or time/date is not set.

Outgoing message

The outgoing message (max 3 minutes) is heard by incoming callers. There are
two separate outgoing messages, one for ANSWER ONLY (callers cannot leave a
message) and one for normal answering function ANS & REC. Please also select
desired answer mode ANSWER MODE , see
. Select ANS. MACHINE. Press OK.
1. Press
2. Select TAM SETTINGS. Press OK.
3. Select OGM SETTINGS. Press OK.
4. Select ANS & REC/ANSWER ONLY. Press OK.
5. Select RECORD MESS. Press OK.
6. After the long beep you can record your message (speaking 20 cm from the
keypad). Press OK.
7. The message will be played back to you. Repeat the above to change.
p.10.
English
Setup from handset, p. 7
9
/.