Specifications - Crestron QM-FTMCSC Operation And Installation Manual

FlipTop Media Center with Storage Compartment
4 • FlipTop Media Center with Storage Compartment: QM-FTMCSC
rating of 15 ns/100 meters (100 meters = 328 feet), connecting the
QM-FTMCSC transmitter with 150 feet of cable to a QM-MD7x2 switcher,
and then using another 150 feet to connect the QM-RMCRX-BA receiver,
the accumulated skew over the entire 300 feet should not exceed 15 ns.

Specifications

Specifications for the QM-FTMCSC are given in the following table.
QM-FTMCSC Specifications
SPECIFICATION
Cresnet Power Usage
Default Network IDs
Video Formats
Video Detection
Firmware
2-Series Control System
1,2
Update Files
Connectors
Computer Input
Computer Audio
Composite Video
Composite Video Audio
S-video
S-video Audio
QuickMedia Output
Cresnet
Ground
Microphone
Video
Types
Video Sensing
Gain
Maximum Input Voltage
Input Impedance
Bandwidth
(Composite &
S-video)
Max Resolution/Refresh
Rate (RGB)
H and V Sync (RGB)
Specifications continued on the following page.
Crestron QM-FTMCSC
DETAILS
8 Watts (0.33 Amp @ 24 VDC)
0A
Composite, S-video, RGBHV, RGsB, YP
Within 2 seconds
QM-FTSCSC.V.3.05.upg or later
Version 3.125.CUZ (for QM-RMCRX-BA) or
later
(1) DB15HD female, video sensing on
H-sync, and G/Y for component video
(1) 3.5mm mini-jack, computer soundcard
type
(1) RCA (yellow), video sensing
(2) RCA (red and white)
(1) Mini-DIN 4-pin, video sense on luminance
signal
(2) RCA (red and white)
(1) RJ-45 CAT5E/CAT6
(2) 4-pin terminal blocks
(1) Ground Terminal
(2) 5-pin Terminal Blocks
Composite, S-video, and RGB/component
Automatic sensing of composite, S-video
(luminance), component (G/Y), and RGB
(H-Sync)
0 dB (unity gain, 75 Ohm termination)
1.0 V
p-p
75 ohms
> 100 MHz (-3 dB) at unity gain
1600 x 1200 @ 60 Hz vertical rate with
CAT5/5E/6 cable length of 100 meters and
skew rating ≤ 15 ns / 100 meters
5.0 V max into 1 KΩ
p-p
Operations & Installation Guide - DOC. 6307A
P
B R