Table of Contents
Advertisement
Crestron QM-FTMCSC
125V – 50/60Hz 10A
Operations & Installation Guide – DOC. 6307A
FlipTop Media Center with Storage Compartment
NOTE: When transmitting S-video, luminance uses the green video pathway,
and chrominance uses the red video pathway. When transmitting composite
video, the signal is carried on the blue video pathway.
NOTE: Always use CresCAT-QM cable to make QuickMedia connections.
NOTE: CresCAT-QM siamese cable includes four additional wires for making
Cresnet connections.
AC Power
Connect the six-foot (183 cm) grounded AC line cord to supply AC power to the
outlet on the topside of the QM-FTMCSC.
The international version (QMI-FTMCSC) is equipped with a standard
IEC-320 electrical appliance coupler. The IEC (International Electrotechnical
Commission) is the international standards and conformity assessment body for
all fields of electrotechnology.
Indicators
PWR (Power)
This LED illuminates when 24 volts DC is supplied to the QM-FTMCSC from
Cresnet.
NET
This LED illuminates when communication between the control system and the
QM-FTMCSC is established (the unit is polled on the network). Illumination
indicates that the SIMPL Windows program currently loaded has a network
device defined at the same Net ID as the QM-FTMCSC.
Bargraphs
Two sets of eight-segment programmable red LEDs are provided that can be
programmed to display audio level settings. The LEDs display is proportional to
the input and can be set from zero to 100%. Refer to "Buttons" on page 40 for
programming details.
NOTE: Indicators are not included with NB models.
SETUP LED and Pushbutton
The QM-FTMCSC is Touch-Settable ID-ready. The SETUP pushbutton and its
associated LED are located on the bottom side and are used for setting a units
network ID during the initial configuration of a Cresnet system or when the
device is being added/replaced.
FlipTop Media Center with Storage Compartment: QM-FTMCSC • 13
Advertisement
Table of Contents
