Crestron QM-FTMCSC Operation And Installation Manual page 22

FlipTop Media Center with Storage Compartment
18 • FlipTop Media Center with Storage Compartment: QM-FTMCSC
Button Installation
To replace the large buttons with small buttons, follow this procedure.
A 1/16" Allen (hexhead) wrench is required to remove the button faceplate.
1. Remove the four Allen screws that secure the button faceplate.
2. While holding adjacent buttons in place, carefully pull the button(s) to
be replaced from the rubber membrane.
3. Carefully press the two small replacement buttons in place, making
sure LED window faces up. Use care not to dislodge the membrane and
circuit board.
NOTE: The removable buttons fit snugly on the rubber membrane. Remove
carefully to avoid pulling the membrane from the unit.
4. The divider bar slips into the slots on the back of the faceplate.
5. Replace the faceplate.
Button Installation
Cable Management Plate
The QM-FTMCSC is shipped with a cable management plate. Use the following
instructions for installation.
Parts Supplied with Cable Management Plate
PART DESCRIPTION
Small Cable Bushing, 5/16 inch ID, 0.5 inch OD
Large cable Bushing, 0.55 inch ID, 0.80 inch OD
Cable Support Plate
Tie Wrap
Computer RGB Cable, VGA to VGA, 6 ft long
Computer Audio Cable, 3.5 mm Stereo, 6 ft long
#4 x 1/4 LG black mounting screws
Crestron QM-FTMCSC
Operations & Installation Guide - DOC. 6307A
QUANTITY
2
1
1
3
1
1
4