Crestron QM-FTMCSC Operation And Installation Manual page 23

Crestron QM-FTMCSC
Operations & Installation Guide – DOC. 6307A
FlipTop Media Center with Storage Compartment
Tools Required:
Phillips screwdriver
•
Small flat-blade screwdriver (for connecting the VGA cable)
•
The cable support plate should be installed before mounting the QM-FTMCSC
to a surface. The cables are looped through the cable support plate.
1. Place the bushings on the cables (three bushings supplied). Use the
large bushing for the VGA cable.
2. Thread the cables through the appropriate slot on the plate.
3. Snap the bushings into the plate slots.
4. Feed all the excess cable through the opening.
5. Attach the plate using the four #4 x ¼ LG black mounting screws
(supplied).
6. Connect the cables to the appropriate connector on the bottom of the
QM-FTMCSC.
7. The cables may be secured to the bottom bar using the supplied tie
wraps.
Cable Management Plate Installation
NOTE: Ensure that the cables have sufficient clearance to enable smooth
movement. Allow approximately 40 inches (102 cm) from the top surface of the
FlipTop box.
FlipTop Media Center with Storage Compartment: QM-FTMCSC • 19