Crestron QM-FTMCSC Operation And Installation Manual page 39

Crestron QM-FTMCSC
Operations & Installation Guide – DOC. 6307A
FlipTop Media Center with Storage Compartment
QM-FTMCSC Basic Controls - Signal Descriptions
SIGNAL TYPE
AND NAME
Digital output:
< RGB Detect >
Digital output:
< Composite Detect >
Digital output:
< SVideo Detect >
Digital output:
< YPbPr Detect >
Analog input :
< VidInputSelect >
Analog output :
< VidInputSelect_F >
Analog input:
< AudInputSelect >
Analog output:
< AudInputSelect_F >
Analog input:
< CompForRGB_Aud >
Analog output:
< CompForRGB_Aud_F >
Continued on the following page
FlipTop Media Center with Storage Compartment: QM-FTMCSC • 35
DESCRIPTION
Indicates that TTL H-sync is detected on the
COMPUTER input. The feedback remains high for as
long as video is detected.
High/1 = Computer video detected;
Low/0 = No video detected
Indicates that video sync levels are detected on the
VIDEO input. The feedback remains high for as long as
video is detected.
High/1 = Composite video detected;
Low/0 = No video detected
Indicates that video sync levels are detected on the S-
VIDEO input. The feedback remains high for as long as
video is detected.
High/1 = S-Video detected
Low/0 = No video detected
Indicates that G/Y-sync is detected on the COMPUTER
input. The feedback remains high for as long as video is
detected.
High/1 = Component video detected;
Low/0 = No video detected
Selects the video source that will be switched to the QM
output.
Valid analog values range from 0d to 3d as follows:
0d = No source
1d = COMPUTER (RGB or component on 3 channels)
2d = VIDEO (on one channel) and S-VIDEO (on two
channels)
3d = VIDEO (on one channel) and S-VIDEO (on two
channels)
A value of 2d or 3d switches both the VIDEO and S-
VIDEO sources to the QM output.
The final video source selection is completed at the QM
receiver. Here a value of 2d selects VIDEO; a value of
3d selects S-VIDEO.
Out of range values are ignored.
Indicates the video source(s) present at the QM output.
Selects the program audio source to be switched to the
QM output.
Valid analog values range from 0d to 3d as follows:
0d = No source (mute audio)
1d = COMPUTER AUDIO
2d = VIDEO L and R
3d = S-VIDEO L and R
Out of range values are ignored.
Indicates the audio source present on the stereo
program channel of the QM output.
Sets the source gain compensation for the COMPUTER
AUDIO source.
Valid analog values range from -100d (-10dB) to +100d
(+10dB), adjustable in increments of 0.1dB (1d =
0.1dB).
Indicates the source gain compensation being applied
to the COMPUTER AUDIO source.