Stihl RMI 632 PC-L Instruction Manual page 86

English
Always activate the disabling device before carrying out any inspection, cleaning or maintenance.
Condition
The robotic mower is not
receiving any GPS signal.
The robotic mower cannot be
reached using the iMow App.
84
Possible Cause
Installed perimeter wire too short
– red LED flashes rapidly at
intervals, @ 12.1.
The connection to the satellites is
being established.
3 or fewer satellites within range. No further action required. It can take a few minutes
No GPS signal.
Cellular module inactive.
Robotic mower in standby mode. ► Activate the robotic mower by pressing the button,
Smart phone or tablet is not
connected to the Internet.
Robotic mower not associated
with the correct e-mail address.
Remedy
► Install the STIHL Small Area Module AKM 100
(special accessory).
► Contact an authorized STIHL iMow servicing dealer.
No further action required. It can take a few minutes
for the connection to be established.
for the connection to be established.
► Avoid or remove obstacles that might be blocking
the signal (e.g. trees, canopies).
The cellular module is switched off during linking, then
it is reactivated and the robotic mower can be reached
again.
set "Standard" energy mode.
► Connect the device on which the app is installed to
the Internet.
► Correct the e-mail address.
22 Troubleshooting Guide
0478-131-3052-A