Stihl RMI 632 PC-L Instruction Manual page 28

English
► If you install the perimeter wire around areas smaller than
120 square yards (100 m²),or if the total length of the
perimeter wire is less than 575 ft. (175 m), the STIHL
Small Area Module AKM 100 (special accessory) must
also be installed. For more information, contact your
authorized STIHL iMow servicing dealer.
STIHL recommends making a sketch of the mowing area
that includes the following:
– The contour of the mowing area including important
obstacles, borders and any restricted areas which the
robotic mower must not mow, @ 26.
– The location and position of the docking station, @ 10.3.
– The location of the perimeter wire and any wire
connectors you have installed, @ 11.
NOTICE
Use only perimeter wire and wire stakes authorized by
STIHL.
NOTICE
The maximum distance between the robotic mower and any
perimeter wire must not be more than 115 ft. (35 m), since
otherwise the wire signal is no longer recognizable.
26
NOTICE
Especially when installing with a wire laying machine, make
sure that the perimeter wire runs loosely from the spool.
Avoid pulling on the perimeter wire. Tensile stress can lead
to wire breaks.
The perimeter wire (1) is installed on the ground and fixed in
place with wire stakes (2) every 3.3 ft. (1 m). Stakes may
need to be closer together if the ground is uneven. This
prevents the wire from being cut by the mower blade.
To install the perimeter wire around an internal docking
station:
2
1
A
► Secure the perimeter wire (1) with a wire stake (2) on the
left side (A) or on the right side (B) of the docking station,
next to a wire channel in the base plate.
► Leave a section of wire (1) with a length of approximately
a = 4.92 ft. (1.5 m). This segment will later be connected
to the docking station.
10 Installing the Robotic Mower
B
0478-131-3052-A
1