Stihl RMI 632 PC-L Instruction Manual page 76

English
Message
0302 – Drive motor fault
Temperature range
exceeded
0305 – Drive motor fault
Left wheel is stuck
0402 – Drive motor fault
Temperature range
exceeded
0405 – Drive motor fault
Right wheel is stuck
0502 – Mowing motor
fault
Temperature range
exceeded
0505 – Mowing motor
fault
Mowing blade blocked
0701 – Battery
temperature
Outside temperature
range
0703 – Battery
discharged
0704 – Battery
discharged
1000 – Rollover
Too steep of slope
1010 – iMow raised
Press OK to release
74
Possible Cause
Temperature in left drive motor too high.
Overload at left drive wheel.
Temperature in right drive motor too high.
Overload at right drive wheel.
Temperature in mowing motor too high.
– Dirt between carrier plate and mowing deck
housing.
– Mowing motor cannot be switched on.
– Mowing motor overloaded.
Temperature in battery too low or too high.
See message 0100.
See message 0100.
Tilt sensor has detected a rollover.
Robotic mower has been lifted by the hood.
22 Troubleshooting Guide
Remedy
► Allow the robotic mower to cool down.
► Clean the robotic mower.
► Level out any uneven areas (holes,
depressions) in the mowing area.
► Allow the robotic mower to cool down.
► Clean the robotic mower.
► Level out any uneven areas (holes,
depressions) in the mowing area.
► Allow the robotic mower to cool down
► Clean mowing blade and mowing deck.
► Clean carrier plate.
► Set higher cutting height.
► Level out any uneven areas (holes,
depressions) in the mowing area.
► Allow the robotic mower to warm up or cool
down.
► See message 0100.
► See message 0100.
► Place the robotic mower on its wheels, check
for damage and confirm the message by
pressing the OK button.
► Check the movement of the hood and confirm
the message by pressing the OK button.
0478-131-3052-A