Installing Reserve Wire; Using Wire Connectors - Stihl RMI 632 PC-L Instruction Manual

English
To install the perimeter wire at a slope with an incline of 5°
to 15°:
► Route the perimeter wire (1) past the top edge of the
slope, keeping a minimum clearance of a = 19.7 in.
(0.5 m).
► If the incline exceeds 15°, route the perimeter wire so that
the robotic mower will stop before it reaches the edge of
the slope. The top edge of the slope and the slope itself
should remain outside the mowing area.

11.13 Installing Reserve Wire

Installing reserve lengths of perimeter wire at regular
intervals will make it easier to later modify the mowing area
or placement of the docking station if that should become
necessary.
44
1
5-15
1
15
To install reserve wire:
1
a
► Route the perimeter wire (1) between 2 wire stakes
spaced approximately a = 3.3 ft. (1 m) apart.
► Attach the reserve wire to the ground in the center using
an additional wire stake.

11.14 Using Wire Connectors

WARNING
To reduce serious or fatal injury or property damage from
fire or electric shock, use only wire connectors authorized by
STIHL.
Wire connectors are designed to link two loose ends of
perimeter wire to extend the perimeter wire or to connect
loose wire ends caused by a breakage. They are filled with
gel to prevent premature wear or corrosion of the wire ends.
► Note the positions of the wire connectors on your sketch
of the mowing area, @ 11.2.
11 Installing the Perimeter Wire
0478-131-3052-A