Calibration Menu; Diagnostics Menu; Setup Menu - Crestron CT-3000 Operation Manual

CRESTRON

Calibration Menu

Calibration of the touchscreen is required if the active touch area of a button does
not coincide with the button's image. Select the TOUCH SCREEN CALIBRATION
button to display the Calibration Menu, shown below. The Calibration Menu offers
the choice to initiate calibration with the Perform Calibration button or return to the
previous screen with the Return to Main Menu button. Choose an option by
touching the correct button. When touching the screen, be as accurate as possible. If
you proceed to calibrate the touchpanel, the screen prompts you with the message
"Touch Screen Calibration Menu" nearly centered on the display. Another message,
"Touch Upper Left Corner", appears in the upper left corner. Touch the corner of
the screen to initiate calibration. Another message, "Touch Lower Right Corner",
appears in the lower right corner. Touch the corner of the screen to return to the
Main Menu.
Calibration Menu

Diagnostics Menu

The DIAGNOSTICS button from the Main Menu should only be used under
supervision from a CRESTRON technical support representative during telephone
support. The options available from the Diagnostics Menu, shown below, are
numeric in nature and their interpretation is beyond the scope of this manual.
Diagnostics Menu

Setup Menu

To obtain the Setup Menu, shown after this paragraph, select and hold the SETUP
button from the Main Menu until the Setup Menu is displayed. Many options for
setting parameters of the touchpanel are available from the Setup Menu and are
explained in the following paragraphs. After setup parameters have been set, select
the Return button, located at the lower right corner of the Setup Menu.
10 Series 3000 Touchpanels Operations Guide - DOC. 8094B