Hardware Hookup - Crestron CT-3000 Operation Manual

8 Series 3000 Touchpanels
CRESTRON
Mounting Detail for Tiltcase Series 3000 Touchpanel

Hardware Hookup

Due to configuration differences (between lectern and tiltcase models), the hookup
diagram differs among Series 3000 touchpanels. Complete the following steps in
the order provided to ensure proper installation of the unit.
1. Before making any connections, review latest revision of network
interconnection drawing (Doc. 5411) or, if necessary, the network
modular cable requirements (Doc. 5682).
2. Connect the touchpanel to the CRESNET II network via a CRESNET
II network cable, shown below, and appropriate interface module.
Recommended CRESNET II Network Cable, Part No. CRE-2S18218
NOTE: Wire is available from Liberty
Wire & Cable (719) 260-0061.
CN-RJ11 OR
ANY LECTERN
MOUNT
CONFIGURATION
A supplied cable assembly (P/N 15717) with 6-position, 6-pin
connectors on each end connects the tiltcase configuration touchpanel
to the CN-RJ11. Connect the CN-RJ11 to the CRESNET II system via
the network cable.
Typical Connection Diagram for Tiltcase Configurations
SIDE VIEW OF TILTCASE CONFIGURATION
#18 AWG Stranded Wire
2x Twisted Pairs
NOTE:
UNITS IN THIS ILLUSTRATION
ARE NOT DRAWN TO SCALE.
CABLE ASSEMBLY
(P/N 15717)
CONNECT TO CNMS,
CNRACK, OR CNRACK-D
Refer to the CRESNET II
Network Cable drawing in
this section of the Guide.
Operations Guide - DOC. 8094B
CNRACK OR
CNRACK-D
OR CNMS