Transfer; Transfer Procedure - GRAVOGRAPH IS200 User Manual

Transfer

You have just created a composition with your engraving software.

Transfer procedure

1. Switch on the IS200 TX machine and wait a few seconds.
The following message will appear on the screen of the machine :
2. From your engraving software, transfer the composition to the IS200 TX machine
The engraving machine displays the number of bytes received :
The following message is displayed for a few seconds as soon as the transfer is complete :
Then the following message is displayed :
The machine is ready to engrave.
First contact
<READY TO RECEIVE>
To engrave
XXXX bytes received
TRANSFER COMPLETED
<READY TO RECEIVE>
To engrave
IS200 TX machine . 23