Table of Contents
Advertisement
Audio Switcher Bussing Kit
4 • Audio Switcher Bussing Kit: CNX-ASBK
NOTE: The remaining steps of this procedure describe the installation of one
CNX-ASBK into one CNX-PAD8. The steps apply to all of the CNX-PAD8s to be
daisy-chained and may be performed in an "assembly line" fashion on all of the
CNX-PAD8s at the same time.
7. Place the CNX-PAD8 right-side-up on a flat surface.
8. Remove the cover screws from the top and sides of the CNX-PAD8.
Remove the Cover Screws
IF NOT RACK
MOUNTED, REMOVE
THESE (3) SIDE
SCREWS ALSO
9. Lift and remove the CNX-PAD8 top cover.
10. From the rear of the CNX-PAD8, remove the 10 back panel cover plate
mounting screws and remove the cover plate.
Back Panel Cover Plate Mounting Screws
10 COVER PLATE
MOUNTING SCREWS
1 - 2
3 - 4
SOURCES
1
2
3
LEFT
RIGHT
CRESTRON
ELECTRONICS INC. ROCKLEIGH, N.J. 07647
11. Making sure that the rear of the PCB assembly faces the rear of the
CNX-PAD8, insert the PCB into the position that was occupied by the
back panel cover plate as shown after this step. Install the PCB with the
10 cover plate screws that were removed.
Crestron CNX-ASBK
REMOVE THREE
(3) SIDE SCREWS
REMOVE FOUR
(4) TOP SCREWS
G
5 - 6
7 - 8
ROOMS
4
5
6
7
8
1
LEFT
RIGHT
Operations & Installation Guide - DOC. 8143
REMOVE THREE
(3) SIDE SCREWS
IF NOT RACK
MOUNTED, REMOVE
THESE (3) SIDE
SCREWS ALSO
CRESNET
24VDC
1A
24
Y
Z
G
2
3
4
5
6
7
8
Advertisement
Table of Contents
