Table of Contents
Advertisement
Audio Switcher Bussing Kit
Problem Solving
8 • Audio Switcher Bussing Kit: CNX-ASBK
Troubleshooting
The table below provides corrective action for possible trouble situations of the
daisy-chained CNX-PAD8s. If further assistance is required, refer to the CNX-PAD8
Operations Guide or please contact a Crestron customer service representative.
Daisy-Chained CNX-PAD8 Troubleshooting
TROUBLE
No audio at all CNX-
Audio source cables
PAD8s.
not connected.
One or more (but not
Bussing cable(s) or
all) CNX-PAD8s not
pin(s) damaged or not
distributing audio.
connected properly.
PCB to PCB cable(s) or
pin(s) damaged or not
connected properly.
Yellow NET LED on
Improper NET ID.
the front panel of a
daisy-chained CNX-
PAD8 does not
illuminate.
Further Inquiries
If you cannot locate specific information or have questions after reviewing this
guide, please take advantage of Crestron's award winning customer service team by
calling the Crestron corporate headquarters at 1-888-CRESTRON [1-888-273-7876].
For assistance in your local time zone, refer to the Crestron website
(www.crestron.com) for a listing of Crestron worldwide offices.
You can also log onto the online section of the Crestron website (www.crestron.com)
to ask questions about Crestron products. First-time users will need to establish a
user account to fully benefit from all available features.
Future Updates
As Crestron adds improvements to the CNX-ASBK, additional information may be
made available as manual updates. These updates are solely electronic and serve as
intermediary supplements prior to the release of a complete technical documentation
revision.
Check the Crestron website (www.crestron.com) periodically for manual update
availability and its relevance. Updates are available from the Download | Product
Manuals section and are identified as an "Addendum" in the Download column.
Crestron CNX-ASBK
POSSIBLE
CORRECTIVE ACTION
CAUSE(S)
Verify that audio source cables
plugged into original or "primary" CNX-
PAD8 are secure.
Check pins and temporarily swap
bussing cable(s). Replace cable(s) if
damaged.
Check pins and temporarily swap PCB
to PCB cable(s). Replace cable(s) if
damaged.
Verify that CNX-PAD8 NET ID
matches NET ID software program.
Refer to "Identity Codes of the CNX-
PAD8s".
Operations & Installation Guide - DOC. 8143
Advertisement
Table of Contents
