Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Crestron CEN-SWPOE-16
Summary of Contents for Crestron CEN-SWPOE-16
- Page 1 Crestron CEN-SWPOE-16 16-Port Managed PoE Switch Operations Guide...
-
Page 2: Regulatory Compliance
Laboratories, Inc. in the United States and/or other countries. Other trademarks, registered tramemarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others Crestron is not responsible for errors in typography or photography. -
Page 3: Table Of Contents
Crestron CEN-SWPOE-16 16-Port Managed PoE Switch Contents 16-Port Managed PoE Switch: CEN-SWPOE-16 Introduction ..........................1 Features and Functions ....................1 Specifications ......................2 Physical Description ....................3 Setup ............................6 Network Wiring ......................6 CAT5 Wiring ....................... 6 Installation ........................6 Hardware Hookup ....................... -
Page 5: 16-Port Managed Poe Switch: Cen-Swpoe-16
PoE+ (802.3at Type 2) from any port, delivering a maximum of 34.2 watts per port up to a total of 255 watts for all ports. PoE at each port can be switched on and off via a Crestron control system allowing equipment to be shut down to save power when not needed. -
Page 6: Specifications
• Configured via simple-to-use Web browser interface • Customizable front panel labeling • AV friendly, single-space rack-mount design Specifications Specifications for the CEN-SWPOE-16 are listed in the following table. CEN-SWPOE-16 Specifications SPECIFICATION DETAILS Ethernet Ports (16) 10/100/1000BASE-T auto-sensing Gigabit Ethernet with PoE Network Standards IEEE 802.3, 802.3u, 802.3ab, 802.3bc,... -
Page 7: Physical Description
This section provides information on the connections, controls and indicators available on the CEN-SWPOE-16. CEN-SWPOE-16 Physical View (Front View) CEN-SWPOE-16 Physical View (Rear View) CEN-SWPOE-16 Overall Dimensions (Front View) 1.70 in (44 mm) Operations Guide – DOC. 7408B 16-Port Managed PoE Switch: CEN-SWPOE-16 • 3... - Page 8 USB computer console port (6 ft cable Pin 4 included); For setup only DESCRIPTION +5 Vdc Pin 1 Pin 2 Data - Data + Ground (Continued on following page) 4 • 16-Port Managed PoE Switch: CEN-SWPOE-16 Operations Guide – DOC. 7408B...
- Page 9 Ethernet interfaces connected to these ports are for intra-building use only and should not be connected to lines that run outside of the building in which the PoE switch is located. Operations Guide – DOC. 7408B 16-Port Managed PoE Switch: CEN-SWPOE-16 • 5...
-
Page 10: Setup
Rack Mounting The CEN-SWPOE-16 can be mounted in a rack or stacked with other equipment. Two “ears” are provided with the CEN-SWPOE-16 so that the unit can be rack mounted. These ears must be installed prior to mounting. Complete the following procedure to attach the ears to the unit. - Page 11 (for example, use of power strips). To install the ears: There are screws that secure each side of the CEN-SWPOE-16 top cover. Using a #1 or #2 Phillips screwdriver, remove the three screws closest to the front panel from one side of the unit.
- Page 12 Crestron CEN-SWPOE-16 Stacking Four “feet” are provided with the CEN-SWPOE-16 so that if the unit is not rack mounted, the rubber feet can provide stability when the unit is placed on a flat surface or stacked. These feet should be attached prior to the hookup procedure.
-
Page 13: Hardware Hookup
NOTE: To prevent overheating, do not operate this product in an area that exceeds the environmental temperature range listed in the table of specifications. Use Crestron Engraver software to print custom labels for the CEN-SWPOE-16’s Label the Buttons front panel buttons and LEDs. Crestron recommends printing on 100-pound paper. -
Page 14: Configuration
Have a question or comment about Crestron software? Answers to frequently asked questions (FAQs) can be viewed in the Online Help section of the Crestron Web site. To post a question or view questions submitted to Crestron’s True Blue Support, log in at http://support.crestron.com. First-time users must establish a user account to fully benefit from all available features. - Page 15 No login is required when accessing the switch through Crestron Toolbox. After the device is selected, options for upgrading firmware and modifying the Ethernet settings and IP table appear on the screen as shown below. Refer to the Crestron Toolbox help files for more information about using these features.
-
Page 16: Using A Web Browser
It also allows changes to the host name, domain name, ports, and DNS servers. Click Modify IP Table to set up a connection between a control system and the switch, allowing the switch to be controlled with a Crestron Studio or SIMPL Windows program. Using a Web Browser To access the configuration utility from a Web browser: Start the Web browser. -
Page 17: Navigating The Configuration Utility
Device Settings, Port Settings, POE Settings and Port Mirroring. The “Device Status” screen is the default screen that appears upon login, as shown in the image above. Navigation Menu Operations Guide – DOC. 7408B 16-Port Managed PoE Switch: CEN-SWPOE-16 • 13... -
Page 18: Device Status
Secondary DNS: Displays the DNS used if the primary DNS fails. • Firmware Version: Displays the version of the firmware installed in the switch. • PS Temperature: Displays the power supply temperature. 14 • 16-Port Managed PoE Switch: CEN-SWPOE-16 Operations Guide – DOC. 7408B... -
Page 19: Device Settings
IP does not function until a reply has been received from the server. Requests are broadcasted periodically by the switch for an IP address. DHCP values can include the IP address, subnet mask, and default gateway. Operations Guide – DOC. 7408B 16-Port Managed PoE Switch: CEN-SWPOE-16 • 15... - Page 20 Click Reset to revert to default settings. DNS Options Use the DNS Options section of the “Device Settings” screen to change the hostname, domain name, and primary and secondary DNS. DNS Options 16 • 16-Port Managed PoE Switch: CEN-SWPOE-16 Operations Guide – DOC. 7408B...
-
Page 21: Login Information
The following settings can be changed: • Hostname: Specifies the name of the switch. Enter the name into the field provided, up to 255 characters long (default is CEN-SWPOE-16). • Domain: Fully qualified domain name consisting of the host name and the DNS suffix. -
Page 22: Port Settings
Select POE Settings in the navigation menu to view the the “PoE Settings” screen. The following columns display information and options for each port on the switch. Refer to the illustration on the following page. 18 • 16-Port Managed PoE Switch: CEN-SWPOE-16 Operations Guide – DOC. 7408B... - Page 23 The “PoE Settings” screen also displays the total power used and the total power allocated for PoE devices. If no PoE devices are connected to the switch, these display “0.0 W”. “PoE Settings” Screen Operations Guide – DOC. 7408B 16-Port Managed PoE Switch: CEN-SWPOE-16 • 19...
-
Page 24: Port Mirroring
Receive: Selects which ports mirror received traffic to the capture port. • Click Save to save the configuration or Reset to clear all port mirroring settings. “Port Mirroring” Screen 20 • 16-Port Managed PoE Switch: CEN-SWPOE-16 Operations Guide – DOC. 7408B... -
Page 25: Problem Solving
Crestron worldwide offices on the Crestron Web site (www.crestron.com/offices) for assistance within a particular geographic region. To post a question about Crestron products, log onto the Online Help section of the Crestron Web site (www.crestron.com/onlinehelp). First-time users must establish a user account to fully benefit from all available features. -
Page 26: Appendix: Fast Ethernet And Gigabit Ethernet
CAT5 cabling, with fiber optics more suited for network backbones. As the new gigabit standard gradually integrates into existing networks, current computer applications enjoy faster access time for network data, hardware, and Internet connections. 22 • 16-Port Managed PoE Switch: CEN-SWPOE-16 Operations Guide – DOC. 7408B... -
Page 27: Return And Warranty Policies
(property or economic damages inclusive) arising from the sale or use of this equipment. Crestron is not liable for any claim made by a third party or made by the purchaser for a third party. - Page 28 Crestron Electronics, Inc. Operations Guide – DOC. 7408B (2034099) 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON 02.13 Fax: 201.767.7576 Specifications subject to www.crestron.com change without notice.