Hyundai Matrix 2003 Owner's Manual page 115

D040B01FC-GAT
FULL SIZE SPARE TIRE (If Installed)
The following instructions for the FULL SIZE
spare tire should be observed:
Check inflation pressure as soon as practical
after installing the spare tire, and adjust to the
specified pressure. The tire pressure should be
periodically checked and maintained at the spec-
ified pressure while the tire is stored.
Spare Tire Pressure
Tire Size
Full Size
Inflation Pressure
210 kPa (30 psi)
3-4
WHAT TO DO IN AN EMERGENCY
D040B01A-AAT
Handling the Spare Tire
HFC4014
Remove the installation bolt to remove the spare
tire. To replace the spare tire in its storage
compartment, tighten the bolt firmly with your
fingers until there is no more play in the spare tire.
D050A01A-AAT
IF YOU HAVE A FLAT TIRE
If a tire goes flat while you are driving:
1. Take your foot off the accelerator pedal and
let the car slow down while driving straight
ahead. Do not apply the brakes immediately
or attempt to pull off the road as this may
cause a loss of control. When the car has
slowed to such a speed that it is safe to do so,
brake carefully and pull off the road. Drive off
the road as far as possible and park on firm,
level ground. If you are on a divided highway,
do not park in the median area between the
two traffic lanes.
2. When the car is stopped, turn on your emer-
gency hazard flashers, set the parking brake
and put the transaxle in "P" (automatic) or
reverse (manual transaxle).
3. Have all passengers get out of the car. Be
sure they all get out on the side of the car that
is away from traffic.
4. Change the tire following the instructions pro-
vided on the following pages.
D060A01A-AAT
CHANGING A FLAT TIRE
D060A01FC
The procedure described on the following pages
can be used to rotate tires as well as to change
a flat tire. When preparing to change a flat tire,
check to be sure the gear selector lever is in "P"
(automatic transaxle) or reverse gear (manual
transaxle) and that the parking brake is set, then: