o "LOCK"
The key can be removed or inserted in this
position.
To protect against theft, the steering wheel locks
by removing the key.
NOTE:
To unlocking the steering wheel, insert the
key, and then turn the steering wheel and key
simultaneously.
C070C01A-AAT
To remove the ignition key
ACC
ON
LOCK
START
C070C01E
1. Turn the ignition key to the "ACC" position.
2. Simultaneously push and turn the ignition key
counterclockwise from the "ACC" position to
the "LOCK" position.
3. The key can be removed in the "LOCK"
position.
DRIVING YOUR HYUNDAI
C050A01A-GAT
STARTING FOR THE GASOLINE ENGINE
C050A01E
WARNING:
Never run the engine in a closed or poorly
ventilated area any longer than is needed to
move your car in or out of the area. The
carbon monoxide gas emitted is odorless
and can cause serious injury or death.
C051A01O-GAT
STARTING FOR THE DIESEL ENGINE
ENGINE COLD
o Turn the ignition key to position "ON" and wait
for the pre-heat indicator light to go out.
o Operate the starter until the engine runs.
ENGINE WARM
Operate the starter. If the engine does not re-
spond on the first attempt, wait several seconds
and try again using the pre-heat.
C050B02S-GAT
NORMAL CONDITIONS
The Starting Procedure:
1. Insert key, and fasten the seat belt.
2. Depress the clutch pedal fully and place the
gearshift lever (manual transaxle) in neutral
or the selector lever (automatic transaxle) in
"P" (park) position.
3. After turning the ignition key to the "ON"
position, make certain all warning lights and
gauges are functioning properly before start-
ing the engine.
4. On vehicles equipped with the diesel preheat
indicator light, turn the ignition key to the "ON"
position. The diesel pre-heat indicator light
will first illuminate in amber, and then after a
short time, the amber illumination will goes
off, indicating that preheating is completed.
Amber lamp ON
Amber lamp OFF
C050B01HP
2- 3
Need help?
Do you have a question about the Matrix 2003 and is the answer not in the manual?