Attaching The Drum Unit To The Three Point Hitch - IBEX TS51C Assembly And Quick Start Manual

Ibex TS51C Drum Mower Assembly Guide Copyright 2020 Ibex Equipment Co.

Attaching the Drum Unit to the Three Point Hitch

Place the drum unit so that it is oriented as shown in Figure 13. Be sure the PTO spline shafts face each other.
Figure 13 move the drum unit over to the three point hitch assembly like this
You will use the swivel tee subassembly shown below to connect two lift arms to the three point hitch
assembly.
Figure 14 swivel tee assembly
Figure 15 the cap and hardware are shown here for the swivel tee
Put the swivel tee through the hole, without the cap, so that the cap goes on top. Install the nut & bolt only until
you feel some resistance – don't tighten all the way as the bolt will need to come back out to mount the top arm
later. You will need either an adjustable wrench or a 30mm socket to secure the nut.
Page | 9