Blade Installation - IBEX TS51C Assembly And Quick Start Manual

Ibex TS51C Drum Mower Assembly Guide Copyright 2020 Ibex Equipment Co.
Figure 10 level the 3 point hitch unit with the top link

Blade Installation

The 6 cutting blades that come with the mower are installed and changed with the blade tool. The blade tool is
stored on the top of the spring arm that connects the 3 point hitch to the drum unit, shown here fully assembled.
Figure 11 blade tool
Find the 6 blades and separate them. Install them with the beveled edges face up. Using the blade tool, pry open
the drums and install the blade by fitting the hole of the blade over the pin inside. For safety purposes, never
place your hand or fingers inside the opened space between the discs. Position the tool, raise the arm, install the
blade, and let the tool arm down. Be sure the blade is on the pin and swings freely.
Figure 12 installing a blade
Page | 8