IBEX TS51C Assembly And Quick Start Manual page 19

Ibex TS51C Drum Mower Assembly Guide Copyright 2020 Ibex Equipment Co.
manufacturer of the PTO shafts recommends adding an inch and a half to the amount to cut off the plastic tube
and the steel telescoping tube of each half of the PTO.
Figure 39 mark overlap length
The overlap length is 150mm for our tractor. Add an inch and a half (40mm) to that for our cutoff length. The
amount to cut off is 190mm. That will be 19 cm on a typical ruler. These measurements are metric because the
instructions given by the manufacturer of the PTO are in metric.
Figure 40 cut off length marked
Cut the measured length of plastic tube, leaving the steel shaft inside not cut.
Figure 41 plastic tube cut
Use the cut length of plastic tube to mark the remaining 3 cuts. Align the end of the tube with the end of the
shaft as shown in Figure 42.
Page | 19