Attaching The Drum Unit - IBEX TS51C Assembly And Quick Start Manual

Ibex TS51C Drum Mower Assembly Guide Copyright 2020 Ibex Equipment Co.
Next, get the hardware to secure the spring arm to the lower lift arm as shown in Figure 22.
Figure 22 hardware to attach spring arm to lower arm
Connect the lower arm to the top arm as shown in Figure 23. Be sure the bolt goes through the loop on the
spring inside the top arm. The lower arm will need to be raised up at an angle to line everything up.
Figure 23 top spring arm attachment to lower arm

Attaching the Drum Unit

Position the drum unit so that the center pivot holes line up when the arm assembly is pushed down. If you are
working by yourself, using a ratchet strap to pull down the spring loaded arm will make this operation easier.
Figure 24 push the lower arm down to line up with drum unit
The centers must be lined up before driving the pin through the hole. Use a long screwdriver, long punch, or
something similar to line up the holes. Do not force the pin through, as you can damage the plastic bushings. A
little oil on the pin can help. Use the top link to adjust the angle and adjust the three point height on the tractor
to put in best position. Use patience as the pin will not go through easily until it is lined up well. Try nudging
the drum unit to get all holes aligned at the same time.
Page | 12