IBEX TS51C Assembly And Quick Start Manual page 3

Ibex TS51C Drum Mower Assembly Guide Copyright 2020 Ibex Equipment Co.
Figure 23 top spring arm attachment to lower arm ............................................................................................... 12
Figure 24 push the lower arm down to line up with drum unit............................................................................. 12
Figure 25 holes are close to being aligned ............................................................................................................ 13
Figure 26 nut and washer installed on pivot pin ................................................................................................... 13
Figure 27 transport lock and rubber grip installation............................................................................................ 13
Figure 28 connect the driveline with one-way clutch ........................................................................................... 14
Figure 29 guard chains attached ........................................................................................................................... 14
Figure 30 shaft with slip clutch end ...................................................................................................................... 14
Figure 31 restrictor plate with hardware ............................................................................................................... 15
Figure 32 plate shown installed from side ............................................................................................................ 15
Figure 33 front guard has 6 holes ......................................................................................................................... 16
Figure 34 eight sets of fasteners used for attaching guard frame ......................................................................... 16
Figure 35 curtain installed with 2 holes for toe guard facing forward.................................................................. 16
Figure 36 curtain straps secure to the guard frame ............................................................................................... 17
Figure 37 correct oil level in drum gearbox.......................................................................................................... 17
Figure 38 PTOs installed to mark overlap ............................................................................................................ 18
Figure 39 mark overlap length .............................................................................................................................. 19
Figure 40 cut off length marked............................................................................................................................ 19
Figure 41 plastic tube cut ...................................................................................................................................... 19
Figure 42 align end of tube to end of shaft ........................................................................................................... 20
Figure 43 use tube to mark the cut length to steel shaft........................................................................................ 20
Figure 44 shaft is marked to cut off same length as plastic tube .......................................................................... 20
Figure 45 clamp on the part of the shaft that is being cut off, then cut ................................................................ 20
Figure 46 burrs and shavings must be removed.................................................................................................... 21
Figure 47 burrs removed with a file, grinder and power wire wheel. ................................................................... 21
Figure 48 spread grease inside outer shaft ............................................................................................................ 21
Page | 3