Three Point Hitch - IBEX TS51C Assembly And Quick Start Manual

Ibex TS51C Drum Mower Assembly Guide Copyright 2020 Ibex Equipment Co.

Three Point Hitch

The 2 lift pins must be secured to the 3 point hitch. Position the three point hitch so the two arms face up. Find
the two lift pins and the 2 smaller roll pins (spring pins) shown below. Oil the holes in the pins and the hitch
then oil the roll pin. Secure the roll pin with locking pliers and drive through the holes with a hammer. The pins
can be installed in a different configuration than shown, for example if the width of your tractor's lift arms is
narrow, you may want to install the pins facing inward.
Figure 8 install the pins in the arms as shown on both sides
Move the 3 point hitch assembly over to the back of your tractor. Attach to the tractor lift arms and install the
lynch pins.
Figure 9 attached to lift arms
Lift the 3 point hitch unit up and install the top link pin. Adjust the length of the top link to make the 3 point
hitch close to straight up and down.
Page | 7