IBEX TS51C Assembly And Quick Start Manual page 16

Ibex TS51C Drum Mower Assembly Guide Copyright 2020 Ibex Equipment Co.
Figure 33 front guard has 6 holes
The 8 sets of hardware shown in Figure 34 are used to fasten the guard frames. Align the pin in the front frame
to the hole in the rear frame, then bolt on. Do not install the bumper guard yet (the double-T shaped frame seen
in Figure 35), as the curtain must be fitted first. You will need 2 wrenches that are 17mm for these nuts and cap
screws.
Figure 34 eight sets of fasteners used for attaching guard frame
Install the curtain with the 2 cutout holes facing forward, as the bumper guard goes through these holes.
Figure 35 curtain installed with 2 holes for toe guard facing forward
Secure the bumper guard with the remaining screws. Secure the curtain with the included straps.
Page | 16