IBEX TS51C Assembly And Quick Start Manual page 21

Ibex TS51C Drum Mower Assembly Guide Copyright 2020 Ibex Equipment Co.
Repeat the process so that both shaft halves have had the same length removed.
When the cut is complete, there will be metal shavings and burrs that need to be removed.
Figure 46 burrs and shavings must be removed
Using a file, grinder, wire wheel, flap wheel, grinding disk or what have you, de-burr the shafts after you cut
them.
Figure 47 burrs removed with a file, grinder and power wire wheel.
Before re-assembling the shafts, push a rag down into each shaft and then around the outside to clear out debris.
Now that both shaft halves are clean inside and out, grease the inside of the bigger shaft. Re-assemble the shaft.
Figure 48 spread grease inside outer shaft
Page | 21