Table of Contents
Advertisement
ASSEMBLY GUIDE
Make sure the hole is to the back. Look at figure 2 to be certain you have it correctly oriented before
proceeding.
Figure 13 install pin with hole to back
Blade installation
Find the blades and separate them. Install them with the beveled edges face up.
Using the blade tool, pry open the drums and install the blade by fitting the hole of the blade over the pin inside.
Never put your hand or fingers inside the opened drum. The blade tool can slip off if it is raised too high.
Position the tool, raise the arm, install blade let the tool arm down. Be sure the blade is on the pin and swings
freely.
Figure 14 installing blades with the blade change tool
For correct balance, the blades should be replaced in sets. It's always a good idea to keep at least one extra set
on hand during hay season.
2022-01.0 IBEX EQUIPMENT CO.
9
Advertisement
Table of Contents
