Three Point Hitch - IBEX TS51C Assembly Manual

ASSEMBLY GUIDE
The other small guard without a cutout is installed at the drum unit PTO spline.
Figure 6 the other small guard installed on the drum unit

THREE POINT HITCH

Find the two 3 point pins and the 2 smaller roll pins (spring pins) shown in Figure 7 below. The
pins can be installed facing outward or inward to accommodate different lift arm widths, so
you may want to bring the hitch close to your tractor to see how it lines up before you decide
which position to install the pins.
Position the 3 point hitch so the two arms face up. Oil the holes in the pins and in the hitch,
and then oil the roll pin. Secure the roll pin with locking pliers and drive it through the holes
with a hammer.
2022-1.0 IBEX EQUIPMENT CO. 6