Page 1
Installation Guide RevFace15 Version: 1.0 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.
Page 2
Installation Requirements Device Installation Installing on the wall Place the mounting template sticker onto the wall, and drill holes according to the mounting paper. Fix the back plate onto the wall using wall mounting screws. Fix the device into back plate. Use the safety screw to fasten the device to the back plate.
Page 3
Power Connection DC 12V, 3A Recommended AC adapter: 12V 3A To share the power with other devices, use a AC adapter with higher current ratings. Port Introduction RJ45 Port Power RS232_TXD RS232 RS232_RXD Power In 12VIN 12VIN 12V-OUT Power Out IWD0 Wiegand In IWD1...
Page 5
RS485 Connection 12V-OUT IWD0 IWD1 WD0-OUT WD1-OUT +12V 12V-OUT 485+ 485A 485- 485B RS485 Reader Door Sensor, Exit Button & Alarm Connection Alarm Power Alarm Exit Button Door Sensor Detector Power Smoke Detector...
Page 6
Lock Relay Connection The system supports both Normally Opened Lock and Normally Closed Lock. The NO Lock (normally open when powered) is connected with 'NO' and 'COM' terminals, and the NC Lock (normally close when powered) is connected with 'NC' and 'COM' terminals. The power can be shared with the lock or can be used separately for the lock, as shown in the example with NC Lock below: 1) Device not sharing power with the lock 2) Device sharing power with the lock...
Page 7
Download Center Use the mobile phone and scan the QR Code to download the User Manual, Installation Guide and Quick Start Guide. Download Center...
Need help?
Do you have a question about the RevFace15 and is the answer not in the manual?
Questions and answers