Biannual Check; Annual Check; Damage To Paintwork; Cleaning - BRAMIDAN B3 Operating Instructions Manual

Biannual check:

The oil level is checked twice a year, see the table below.
When the platen is in the top position, the distance from the tank's edge to the oil should be:
B-series, model
B3
B4
Since the hydraulic oil's lifespan is heavily dependent on the operating temperature, this should
be at 86-140 Fahrenheit. Therefore, a cooling system should be mounted on the hydraulic
system (optional equipment) for continuous operation.
Lubricate the baler's cylinders, steering rod, and spindle (hand wheel) at least twice a year. The
oil nipples fit on a standard hand pump.

Annual check:

At least one annual service check is recommended where the baler's electrical and hydraulic
systems are reviewed and defective parts and oil are replaced in order to keep the baler in an
operational and safe condition. Service inspections can be ordered from the dealer.
At least one safety check on the baler must occur annually. See chapter 16, Checklist for
CAUTION
safety check.
The oil should be changed at least once a year. The place where the oil is being filled, as well as
the tools used for filling the oil must be completely clean.
The filter in the oil tank should be changed after max. 2000 operating hours or at least every five
years. Filter changes must be carried out by authorised personnel.

Damage to paintwork:

Major damage to paintwork can be repaired using a 2-component paint, which can be purchased
from the dealer. Minor scuffs, etc. can be repaired using an ordinary paint.

Cleaning:

The baler is cleaned with a hand brush and an ordinary soft cloth, don't use water or high
pressure cleaners, etc.
Baler
Distance in inches
1 inches
1 inches
14 Vedligeholdelse USA.fm • Page 30