Finishing The Bale Prematurely - BRAMIDAN B3 Operating Instructions Manual

Finishing the bale prematurely:

If you want to finish the bale before it has reached its maximum (before the finish indicator button
lights), this is done as follows:
Baler B3 and B4
The platen must be in the top position, and the green
start button must be lit.
Open the filling door and pull the strap over the bale. Cut
the straps to the appropriate length and let them hang
out over the edge of the door.
Close the filling door.
For normal operation:
Press on the orange finish indicator button for more than
3 seconds. (The finish indicator button is not lit).
For automatic start:
Press on the orange finish indicator button, while the
door is closing and until the button lights up.
The platen will go down and park on top of the bale.
The orange finish indicator button now starts to flash.
Open the doors.
Release the strap loops from the slots in the front of the
chamber.
The shortened straps which were previously hanging
over the edge of the door, are passed through the loops
on the strap's other end and tightened by pulling
upwards. Then finish off by tying a few knots.
11 Ifyldning og komprimering USA.fm • Page 21