Installation - BRAMIDAN B3 Operating Instructions Manual

6 Installation

The baler fulfils the applicable EU requirements on electromagnetic interference, and may be
installed in both residential and industrial environments.
The baler's noise level is initially less than 70dBA. If the baler's noise level exceeds 70dBA, this
will appear on the nameplate on the baler.
The noise level is measured based on an operator's position during the baler's operation, about
39 inches from the operation and at a height of 63 inches.
The baler is designed for temperatures between 32-95 Fahrenheit and a humidity of between 10-
90%.
•
When installing in colder environments, a special artic oil shoud be used (optional
equipment).
•
When installing in warmer environments, a cooling system should be mounted on the
hydraulic system (optional equipment).
For B3: The baler must always be mounted to the floor or wall.
Use the mounting brackets supplied.
Baler
In order to reduce vibrations that may occur during
operation, the baler can be placed on a thick, soft rubber
mat.
6 Installation USA.fm • Page 11