Maintenance; Daily Check; Weekly Check - BRAMIDAN B3 Operating Instructions Manual

14 Maintenance

Before any repair or maintenance on the baler, disconnect the power by removing the
WARNING
plug from the electric socket. If you cannot do this, place a padlock on the baler's repair
switch.
The legally required safety equipment must always be used for all types of repair and
maintenance.
Repairs to the electrical or hydraulic system must only be undertaken by authorized personnel
WARNING
who have the requisite knowledge and skills. Repairs must be carried out in a way that ensures
that operation of the baler can continue safely.
WARNING There must be no alterations or modifications to the baler or its electrical or hydraulic system.

Daily check:

•
Check each day to make sure that no waste is trapped around the platen.
•
Check if the platen's ejection mechanism can be pushed into the platen and then jump out
again, see chapter 13, Ejecting the bale.

Weekly check:

•
Check that the emergency stop works.
•
Check that the baler cannot start when the filling door or main door is open.
•
Check that all covers and screens are intact and attached.
•
Also check that the release rollers on the platen's ejection mechanism can roll and are not
defective or worn out.
•
Also take note of the baler's overall condition.
If there are defects, these must be repaired by authorised personnel who possess the necessary
CAUTION
knowledge and understanding before the baler can be used again.
Baler 14 Vedligeholdelse USA.fm • Page 29