The Function Of The Push Buttons - BRAMIDAN B3 Operating Instructions Manual

The function of the push buttons:

Compression:
When the green start button is activated, the platen runs a cycle where the waste is compressed
and the platen returns to the top position. For models with automatic doors, the door is
automatically closed before the platen begins the cycle.
See chapter 11, Filling and compression.
Binding the bale:
When the orange finish indicator button lights/flashes, the bale has reached its maximum and the
platen is parked on top of the bale. From here on, it is no longer possible to interrupt the process,
which must be concluded with binding and bale-ejection.
The bale size is set at the factory. The bale size can be permanently changed if necessary.
Contact the dealer for more information.
See chapter 12, Binding.
Finishing the bale prematurely:
If you want to finish the bale before it has reached its maximum (before the finish indicator button
is illuminated/flashes), this is done by pressing the orange finish indicator button for more than 3
seconds.
See chapter 11, Filling and compression, Finishing the bale prematurely.
Parking the platen on the bale (occasional):
Should the platen occasionally be parked on the bale to maintain the pressure with e.g.
expanding materials, press on the start button (B) for a minimum of 3 seconds while the platen is
on its way down.
When the platen is moved back to the top position, press once on the green start button.
To park the platen on the bale (occasionally) see chapter 8 Operating Principles.
Baler 9 Betjeningspanelet USA.fm • Page 18