Additional Functions - BRAMIDAN B3 Operating Instructions Manual

Additional functions:

The following functions are not installed when the machine leaves the factory, and require an
adjustment of the actual control system. Contact the dealer for more information.
Automatic start:
The baler starts when the filling door is closed, and it is therefore unnecessary to start it by
activating the green start button.
Multiple press cycles after each start:
When the baler is activated, the platen runs the required number of press cycles.
Pause in the top position:
The platen remains in the top position for the required length of time. There is no reason for this
except when running with more than one cycle or for testing.
Pause in the lowest position:
The platen remains in the lowest position on the bale for the required length of time. This function
can be used when it is known how frequently the baler is used, and an alternative is required to
parking the platen on top of the bale (occasionally or permanently).
Parking the platen on the bale (permanent solution):
If you want a permanent solution where the platen parks on top of the bale every time in order to
hold the pressure, for instance on expanding materials, the baler can be run with half press
cycles.
To park the platen on the bale (occasionally) see chapter 9 The Operating Panel.
Baler 8 Funktionsprincipper USA.fm • Page 16