Advertisement
Note
Note
7.3.7
Configuring the PT Setting
7–10
Example settings for the
Ct-S
200/5 A: set the
Ct-n
800/5 A: set the
Ct-n
2000/5 A: set the
Ct-n
10000/5 A: set the
The value for amps is a product of the
4.
Press ENTER to scroll through the other
Pressing DOWN or RIGHT displays the password screen (see Reset Mode on
page 7–4 for details).
5.
Press MENU to return to the main configuration menu.
and
are dictated by Primary Voltage.
Ct-n
Ct-S
is secondary Voltage.
Ct-d
Use the following procedure to program the PT setting.
1.
Push the DOWN Button to scroll through the configuration mode parameters.
2.
Press ENTER when
flashing) as shown below.
This will display the
(PT numerator) screen.
Pt-n
3.
Press ENTER again to change to display the
4.
Press ENTER again to select the to
CHAPTER 7: CONFIGURING THE METER USING THE FRONT PANEL
value are shown below:
value for "200" and the
value for "800" and the
value for "2000" and the
value for "1000" and the
Ct-n
and the
Ct-n
CFG
is the "active" parameter (i.e. it is in the "A" screen and
Pt
Pt-S
EPM 2200 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
value for "1"
Ct-S
value for "1"
Ct-S
value for "1".
Ct-S
value for "10".
Ct-S
values.
Ct-S
parameters.
(PT denominator) screen.
Pt-d
(PT scaling) value.
Advertisement
