Table of Contents
Advertisement
POLARIS REMOTE
- for Zone 1/21
POLARIS Remote KVM Analog 15" / 19.1"
8.
Operation
8.1
Putting into operation for the first time
8.1.1
Length adjustment POLARIS Remote to local unit STP
Technical data subject to change.
08/2019
The POLARIS series does not have any ON/OFF switch.
The device can be put into operation after the final check has been made.
Compatibility
The system was tested with different devices. Nevertheless, it is impossible to
guarantee that it will function correctly with every keyboard/mouse/ monitor and
motherboard.
It is necessary to make a length adjustment for the distortions on the STP cable when
installing the first time. This length must be adjusted via the POLARIS Remote keyboard.
(1)
Request the command menu with
(2)
Set the approximate cable length by multiple entry of the command
+
The cable length is increased by 25 m each time the command is executed.
(3)
If necessary, the picture can be finely tuned with
+
or
+
and
+
or
+
(4)
With cable lengths >100 m the command 'Signal delay fast setting for GREEN'
(
+
) may improve the picture.
(5)
Store the settings and leave the command mode with
See manufacturer's manual for further information on the functions of the local unit.
+
+
.
.
Operation
EN 37/48
Advertisement
Table of Contents
