Table of Contents
Advertisement
CHAPTER 6 - INSTALLATION GUIDE
1. Please refer to the "Troubleshooting and Installation Tips"
section in Chapter 7 for details on avoiding installation issues.
2. The installation consists of mounting the display inside the RV,
cutting and fastening the senders to the sides of the holding
tanks, connecting wiring, and programming the display. When
wiring DO NOT use spade connectors to join wires, only use
crimp on butt connectors or solder the wires together.
3. Mount the display by cutting a hole in the wall 3" wide by 1
high and bringing the wiring out through the hole to connect to
the display panel connector.
4. Connect the wiring according to the following table. It is easier
to connect the wiring to the display connector first, and then
plug the connector into the display panel. The senders need
to be grounded to a single ground wire from the display. Make
sure that the system ground is connected to the breaker panel
ground.
White 18 gauge
Red 18 gauge
Black 18 gauge
Blue 18 gauge
Orange 18 gauge
5. Determine where to mount the senders on the tanks. They will
need to have a flat area on the side of the tank large enough so
the whole width of the sender is in contact with the side of the
tank, all the way from the top to the bottom of the tank. Make
sure that any metal is at least 1" away from either side or the top
and bottom of the sender, and at least 2" away from the face of
the sender. Clean the area well so that there is no dust, grease,
oil, water, etc., that would prevent the adhesive on the sender
from sticking.
6. Measure the height of the tank to determine which sender
configuration to use and how long the senders should be. Refer
to the following table.
CAUTION: DO NOT mix sender types when stacking senders.
W
Page 16
Wire Colours on Connector
Wire Color
Function
Pump LED
+12V
Ground
Tank Senders
Common Alarm Output
709-N2K NLP/709-N2KP NLP Manual
"
7/8
Hide quick links:
Advertisement
Table of Contents
