Chapter 6 - Installation Guide; (New Oem Installations Only) - Garnet SEELEVEL II 714 Manual

CHAPTER 6 - INSTALLATION GUIDE

1. The installation consists of mounting the display inside the RV,
cutting and fastening the senders to the sides of the holding
tanks, connecting wiring, and programming the display.
2. Mount the display by cutting a hole in the wall 2 1/4" wide by
4 3/4" high and bringing the wiring out through the hole to
connect to the display panel connector.
3. Connect the wiring according to the following table. It is easier
to connect the wiring to the display connector first, and then
plug the connector into the display panel. The sender needs
to be grounded to a single ground wire from the display.
Green 22 gauge
Blue 22 gauge
Black 18 gauge
Red 18 gauge
Green/Yellow 22 gauge
White/Orange 22 gauge
White/Blue 22 gauge
Yellow 22 gauge
4. Determine where to mount the senders on the tanks. They
will need to have a flat area on the side of the tank large
enough so the whole width of the sender is in contact with
the side of the tank, all the way from the top to the bottom
of the tank. Make sure that any metal is at least an inch away
from the sender. Clean the area well so that there is no dust,
grease, oil, water, etc., that would prevent the adhesive on the
sender from sticking.
5. Measure the height of the tank to determine how long the
senders should be. For tanks less than 13" tall, follow step 6.
For tanks greater than 13" tall, follow step 7.
6. For tanks less than 13" tall, a single sender is used. The
sender ends should be 1/4" to 3/4" away from the top and
bottom of the tank, to allow for the thickness of the tank top
and bottom and any bows in them (see the diagrams). The
Page 12
Wire Color

(NEW OEM INSTALLATIONS ONLY)

Function
LPG sensor
Tank Senders
Ground
+12V power input to monitor
Pump switch - normally open
Pump switch - common
Pump switch - normally closed
Pump LED
714 / 714-P Manual