Advertisement
Available languages
Available languages
• Never lay the power tool down until the diamond
cutting disc has come to a complete stop. The spin-
ning disc may grab the surface and pull the power tool
out of your control�
• Do not run the power tool while carrying it at
your side. Accidental contact with the spinning dia-
mond cutting disc could snag your clothing, pulling the
disc into your body�
• Do not operate the power tool near flammable
materials. Sparks could ignite these materials�
• Do not use diamond cutting disc that require liq-
uid coolants. Using water or other liquid coolants may
result in electrocution or shock�
• Avoid stopping the power tool motor when under
load�
• Avoid overheating your power tool, when using it for
a long time�
• Never operate the power tool over your head level�
• During operation, the diamond cutting discs become
very hot� Do not touch them before they cool�
• If, during operation, the power supply is suddenly
interrupted, to avoid accidental switching on of the
power tool, immediately put the on / off switch to the
off position�
• It is strictly forbidden to slow down the rundown of
the diamond cutting discs using a spindle lock or by
applying force to the lateral surface of the discs� Using
the spindle lock for this purpose will put the power tool
out of action and deprive you of the right to warranty
service�
Caution! Be careful when cutting slots
in load-bearing walls. DIN 1053 part 1 or
country-specific regulations apply to the
slots in the load-bearing walls.
These regulations must be complied with. Before
starting work, consult a responsible static special-
ist, architect or foreman.
Warning: the chemical substances con-
tained in dust generated in sanding, cut-
ting, sawing, grinding, drilling and other
construction industry activities may result
in cancer, congenital deficiency or be harmful to
the fertility. The ion of some chemical substances
shall be:
• Before any repair and replacement work to the ma-
chine, the power plug must be pulled out firstly.
• The transparent two silicon oxide and other ma-
sonry products in the wall bricks and cement; the
chromium arsenic (CCA) in wood with chemical treat-
ment� The harm degree of these substances shall
depend on the frequent degree of you carrying out
these works� If you want to reduce the contact with
these chemical substances, please work in the place
with ventilation and you shall use the appliances with
safety certificates (such as the dust mask designed
with tiny dust filter).
Notice the power voltage: in power connection, you
must confirm that if the power voltage is the same to
the voltage marked in the tool's data plate� If the power
voltage is higher than the appropriate voltage, the acci-
dents will be resulted to the operators, and at the same
time, the tool will be destroyed� Therefore, if the power
voltage has not been confirmed, then you shall never
plug in arbitrarily� On the contrary, when the power
voltage is lower than the required voltage, the motor
will be damaged�
Symbols used in the manual
Following symbols are used in the operation manual,
please remember their meanings� Correct interpreta-
tion of the symbols will allow correct and safe use of
the power tool�
Symbol
English
13
Meaning
Wall chaser
Sections marked gray - soft
grip (with insulated surface)�
Serial number sticker:
CT ��� - model;
XX - date of manufacture;
XXXXXXX - serial number�
Read all safety regulations
and instructions�
Wear safety goggles�
Wear ear protectors�
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Risk of damage to hidden
wiring or household service
lines�
Movement direction�
Rotation direction�
Advertisement
