Table of Contents
Advertisement
16
www.raider.bg
The spray result depends heavily on the smoothness and cleanliness of the surface to be sprayed.
Therefore the surface should be carefully prepared and kept free of dust. Cover all surfaces not to be
sprayed. Cover screw threads or similar parts of the target object. It is advisable to test the spray gun
on cardboard or a similar surface to find the correct setting. Important: Begin spraying outside of the
target area and avoid interruptions inside the target area. An even movement of the spray gun results
in an even surface quality.
V. Taking Out of Operation and Cleaning.
1. Turn the machine off. Activate the trigger guard so that the coating material in the spray gun flows
back into the container.
2. Unscrew the container. Empty any remaining coating material back into the material tin.
3. Pre-clean the container and feed tube with a brush.
4. Pour solvent or water into the container. Screw the container back on.
Use only solvents with a flashpoint over 21°C
5. Turn on the machine and spray the solvent or water into a container or a cloth.
6. Repeat the above procedure until the solvent or water emerging from the nozzle is clear.
7. Turn the machine off.
8. Then empty the container completely. Always keep the container seal free of coating material
residue and check for damage.
9. Clean the outside of the spray gun and container with a cloth soaked in solvent or water.
10. Unscrew the union nut and remove the air cap and nozzle. Clean the air cap and nozzle with a
brush and solvent or water.
Caution! Never clean nozzle or air holes in the spray gun with sharp metal objects.
Assembly.
Put the nozzle onto the gun body and find the correct position by turning it. The rib on the nozzle
should fit into the groove on the gun body. Put the air cap onto the nozzle and tighten it using the
union nut.
Advertisement
Table of Contents
