Viscosity Table - Raider RDP-SSGC20 SOLO User Manual

of exposure in the actual conditions of use (taking account of all parts of the operating cycle such
as the times when the tool is switched off and when it is running idle in addition to the trigger time).
III. Use.
1. Preparing the Coating Material
The paints usually need to be diluted for use with the spray gun. Since information on sprayable
dilutions is seldom given on the material tin, you can use the guidelines in the viscosity table on the
following page (viscosity = consistency of the coating material).
Measuring the Viscosity.
Stir the coating material thoroughly before measuring.
Dip the viscosity test cup completely into the coating material.
Hold the test cup up and measure the time in seconds until the liquid empties out.
Note: This time is called "Runout Time in Seconds".

Viscosity table

Material
1) Oil enamel
2) Oil based primer
3) Oil stain
4) Clear sealer
5) Polyurethane
6) Varnish
7) Lacquer sanding sealer
8) Lacquer
9) Automotive finishes
10) Latex
2. Start-up.
Before connecting to the mains supply, be sure that the supply voltage is identical with the value given
on the rating plate.
Mounting air hose. Insert the air hose tightly in connections on the machine and the spray gun.
The connections can be positioned as desired.
3. Unscrew the container from the spray gun.
4. Aligning suction tube .The container contents are to be sprayed out almost completely. When
spraying horizontal surfaces, turn suction tube forward (A). When spraying objects overhead, turn
suction tube back (B).
5. Set the container on a sheet of paper, pour in the prepared coating material and screw the container
tightly onto the spray gun.
6. Put the machine down only on a level, clean surface. Otherwise the machine could suck in dust,
etc.
7. Hang the machine on your shoulder with the carrying belt.
8. Take the spray gun out of the spray gun holder and point it at the target object.
9. Push the ON / OFF switch on the machine.
IV. Spray Technique.
Run out Time (Sec)
25-60
30-60
No thinning required
No thinning required
No thinning required
20-60
25-35
25-35
20-40
45-90
15