Raider RDP-SSGC20 SOLO User Manual page 13

I. General Safety Instructions.
WARNING!
When using electric tools, basic safety precautions, including the following, should always be followed
to reduce the risk of fire, electric shock and personal injury.
Read all these instructions before operating this product and save these instructions.
For safe operations:
1) Keep work area clean.
Cluttered areas and benches invite injuries.
2) Consider work area environment.
Do not expose power tools to rain. Do not use power tools in damp or wet locations. Keep work area
well lit. Do not use power tools where there is risk to cause fire or explosion.
3) Guard against electric shock.
Avoid body contact with earthed or grounded surfaces (e.g. pipes, radiators, ranges, refrigerators).
4) Keep children away.
Do not let visitors touch the tool or extension condo all visitors should be kept away from area.
5) Store idle tools.
When not in use, tools should be stored in a dry, high or locked up place, out of reach of children.
6) Dc not forces the tool.
It will do the job better and safer at the rate for which it was intended.
7) Use the right mol.
Do not force small tools or attachments to do the job of a heavy duty tool. Do not use tools for
purposes not intended; for example, do not use circular saws to cut tree limbs or logs.
8) Dress properly.
Do not wear loose clothing or jewelers; they can be caught in moving parts. Rubber gloves and non-
skid footwear are recommended when working out doors. Wear protecting hair covering to contain
long hair.
9) Use safety glasses.
10) Connect dust extraction equipment.
If devices are provided for the connection of dust extraction and collection facilities ensure these are
connected and properly used.
11) Secure work.
Use clamps or a vice to hold the work. It is safer than using your hand and it frees both hands to
operate the tool.
12) Do not overreach.
Keep proper footing and balance at all times
13) Maintain tool with care.
Keep cutting tools sharp and clean for better and safer performance. Keep handles dry, clean and
free from oil and grease.
14) Disconnect tools.
When not in use, before servicing and when changing accessories such as blades, bits and cutters.
15) Use outdoor extension leads.
When tool is used outdoors, use only extension cords intended for outdoor use.
16) Stay alert.
Watch what you are doing, Use common sense. Do not operate tool when you are tired.
17) Check damaged parts.
Better further use of the tool, a guard or other part that is damaged should be carefully checked to
determine that it would operate properly and perform its intended function. Check for alignment of
moving parts, free running of moving parts, breakage of parts, mounting and any other conditions
that may affect its operational. A guard or other part char is damaged could be properly repaired or
replaced by an authorized service center unless otherwise indicated in this instruction manual. Have
defective switches replaced by an authorized service facility. Do not use the tool if the switch does
not turn it on and off.
Warning.
The use of any accessory or attachment, other than those recommended, in this instruction manual,
13