Bclo; Beep; Beep Level - Yaesu FT5Dr Advance Manual

2 BCLO

Preventing transmissions when the receive channel is busy.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired setting.
OFF Permits starting a transmission while receiving a signal.
ON Disables transmissions while receiving a signal.
Remark The default setting: OFF

3 BEEP

Set whether or not a beep sound is emitted to confirm when keys are operated, when
scanning reaches the end of a frequency band, or when a band edge/CH1 is encountered.
1. Press and hold the [F
2. Rotate the DIAL knob to select [SELECT], then press the [F
3. Rotate the DIAL knob to select the desired setting referring to the table below.
KEY & SCAN
KEY
OFF
Remark The default setting: KEY & SCAN
4. Press the [BACK] key.
5. Rotate the DIAL knob to select [EDGE], then press the [F
6. Rotate the DIAL knob to select the desired setting referring to the table below.
OFF No confirmation sound is emitted when a band edge/CH1 is encountered.
ON Emits the confirmation sound when a band edge/CH1 is encountered.
Remark The default setting: OFF

4 BEEP LEVEL

Set the volume of the beep sound.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired setting.
HIGH Volume level set to HIGH
LOW Volume level set to LOW
Remark The default setting: LOW
] key  touch [CONFIG]  [2 BCLO]
MENU
] key  touch [CONFIG]  [3 BEEP]
MENU
Emits the beep sound when a key is operated or scanning stops.
Emits the beep sound when a key is pressed.
Mutes the beep sound.
] key  touch [CONFIG]  [4 BEEP LEVEL]
MENU
MENU
58
] key.
MENU
] key.