Simrad SX90 Quick Start Manual page 26

Simrad SX90 Quick Start Guide
• The course and speed of the latest marker is found in the lower right corner of the
view. The values are calculated based on the last two markers you placed and the
time between each placement.
• Relevant information about a priority object can be found in the lower left corner of
the view.
The menu controls which graphical elements that are shown.
Cosmetics
2 At the bottom of the SX90 presentation, select a suitable presentation mode, and
activate the Vertical view.
The view shows you a "vertical slice" of the echo data. The slice is made at the current
bearing. The area covered by the vertical beam is shown as a triangle in the Horizontal
view. You can change the bearing on the
line in a Horizontal view and drag it sideways.
The upper horizontal line in the view represents the water surface.
• Horizontal dotted lines show the depth intervals. Use
menu to toggle these lines On or Off.
Cosmetics
• The selected range is divided into identical distances. These are shown as dotted
circles. They are referred to as range rings.
• The distance and depth of the cursor location is shown in the lower right corner of
the view.
The current tilt is shown with a solid line. You can change the tilt angle by means
of the function on the
Tilt
up and down.
A line of X'es in the vertical views shows the bottom of the purse seine. The depth is
defined for the fishing gear you have chosen. Under
to open the dialog box. For the selected purse, select a depth value. Use
Setup
on the
Depth Cosmetics
The menu controls which graphical elements that are shown.
Cosmetics
3 At the bottom of the SX90 presentation, select a suitable presentation mode, and
activate the 270 Vertical view.
The 270 Vertical view is designed for purse seining. The view combines a horizontal
"bow up" presentation with a vertical slice. The vertical half slice is displayed in the
lower left corner for when the net is set out on the starboard side. If the net is set on the
port side, the vertical slice is displayed in the lower right hand corner. The area covered
by the vertical beam is shown as a triangle in the Horizontal view.
This view makes it easy to keep contact with the school. You can determine its size
distribution, and monitor the position the school relative to the bottom.
24
Main
menu. You can also click on the tilt line and drag it
Main
menu to toggle this line On or Off.
menu. You can also select the bearing
Depth Dividers
, select
Fishing Gear
on the
Fishing Gear
Purse
386619/C