Simrad SX90 Quick Start Manual page 19

•
Position Track
position track permits the SX90 to automatically control the tilt and bearing based
on the movements of your vessel. It locks on a position defined by its latitude,
longitude and depth. The bearing and tilt settings are automatically adjusted to
compensate for the movements of your vessel.
• : A target track permits the SX90 to automatically control the tilt and
Target Track
bearing based on the movements of the chosen target. It locks on the target defined
by its position, heading and speed. The bearing and tilt settings are automatically
adjusted to follow the movements of the tracked target.
A new tracked object is automatically given priority status. Relevant information about
the priority object can be found in the lower left corner of the view. If you change the
tilt or bearing settings manually the priority status is lost.
: Use the trackball to control the cursor in the SX90 user interface.
K
Trackball
Note
The SX90 supports two different operating panels. These are referred to as "Mk1" and
"Mk2". In this publication all descriptions and references are related to "Mk2".
Before you can change the settings related to a view, you must click inside the view to
activate it. The changes you make are by default only valid for the active view. Several of
the functions offer
Apply to All
the views in the current presentation mode.
386619/C
: Use the trackball to control the cursor in the SX90 user interface.A
. If you select your setting is applied to all
Apply to All
Getting started
17